Bosch Professional GRO 10,8 V-LI Original Instructions Manual page 11

OBJ_BUCH-2020-001.book Page
Cordless multi rotary tool
Article number
Rated voltage
Rated speed
Collet chuck-Ø
Spanner flat of collet chuck
Max. outer diameter:
– Cutting disc
– Grinding accessory
– Wire brush
– Grinding disc
– Drill bit
Max. inner shank dimension L
0
Max. shank length
Weight according to
EPTA-Procedure 01/2003
Technical data determined with battery from delivery
scope.
Battery
Permitted ambient
temperature
– when charging
– during operation*
– during storage
Recommended batteries
* Limited performance at temperatures <0
We declare under our sole responsibility that
the product described under "Technical Data"
is in conformity with the following standards or
standardisation documents: EN 60745
according to the provisions of the directives
2009/125/EC (Regulation 1194/2012),
2011/65/EU, 2004/108/EC, 2006/42/EC.
Technical file (2006/42/EC) at:
Robert Bosch GmbH, PT/ETM9,
D-70745 Leinfelden-Echterdingen
Henk Becker Helmut Heinzelmann
Bosch Power Tools
11 Tuesday, November 26, 2013 2:57 PM
GRO 10,8 V-LI
Executive Vice President
3 601 JC5 0..
Engineering
V= 10.8
min -1 5000 –35000
Robert Bosch GmbH, Power Tools Division
mm 3.2
D-70745 Leinfelden-Echterdingen
Leinfelden, 26.11.2013
mm 9.55
Assembly
mm
38
mm
22.5
Battery Charging
mm
20
Use only the battery chargers listed on the
mm 20
mm 3.2
mm 10
mm 35 Note: The battery is supplied partially charged. To ensure
full capacity of the battery, completely charge the battery
in the battery charger before using your power tool for the
first time.
kg 0.6
The lithium-ion battery can be charged at any time
without reducing its service life. Interrupting the charging
procedure does not damage the battery.
The lithium ion battery is protected against deep
discharging by the "Electronic Cell Protection (ECP)".
When the battery is empty, the machine is switched off by
means of a protective circuit: The inserted tool no longer
rotates.
°C
Do not continue to press the On/Off switch after
°C
0...+45 –20...+50
°C –20...+60
GBA 10,8V x,xAh 0-
Observe the notes for disposal.
.
Removing the battery (see figure A)
°C
– To remove the battery 9, press the unlocking buttons
Battery Charge-control Indication
The three green LEDs of the battery charge-control
indicator 8 indicate the charge condition of the battery 9.
LED
Continuous lighting Battery Capacity 3
x green
Continuous lighting Battery Capacity 2
x green
Head of Product Certification
PT/ETM9
accessories page. Only these battery chargers are
matched to the lithium ion battery of your power tool.
18
the machine has been automatically switched off.
The battery can be damaged.
16 and pull the battery out of the machine to the rear.
Do not exert any force.
Meaning
English |
≥2/3
≥1/3
1 619 P 11 460 | (26.11.13)