Page 1
1.As indicated by the picture, remove the 4 bottom left rubber stand and screws by using the screw driver provided. (keep the screws, don't lose them) 2.As indicated by the picture, remove the bottom rubber stand and screws by using the classic screw driver provided.
Page 2
4.Follow the instruction to take off these 2 plastic plates. 5.As indicated by the picture, remove those 3 screws by using the classic screw driver provided. 6.Remove the top plate of the console then those 4 screws.
Page 3
7.As indicated by the picture, unplug the power source.
Page 4
8.Remove the right plastic plate and the metal DVD rom cover, and take off the screws as indicated in the picture. 9.Open the DVD rom ,and follow the instruction of the number to take off the cables.
Page 5
10.Remove those screws. 11.As shown in the picture, unplug the power source of the fan.
Page 6
12.Remove the fan and the flow wind tunnel then take off 3 screws. 13.Remove the black plastic part then take off those 14 screws.
Page 7
14.Take off the tape then remove the metal part. 15.Take off 4 screws and remove the heat sink.
Page 8
16.Remove all the parts from the left plastic plate. 17.Place the rubber stand from the left plate to the same position of the replacement i case.
Page 9
18.put back the metal plate to the replacement i case. 19.replace the mother board, put the indicated small metal plate to that position, then put down the heat sink and put on 4 screws.
Page 10
20.Put on the metal cover and those 15 screws.
Page 11
21.Put on the black plastic bar and 3 screws. 22.Place the fan and the flow wind tunnel, plug on the power source as indicated on the picture then put on 9 screws.
Page 13
24.Put on 4 screws. 25.As shown on the picture, place the protective dust cover to the i case.
Page 14
26.Place the the right plate to the console, put on 4 screws. 27.As shown in the pictures, put on the LED part.
Page 15
28.Put on those parts to the i case face plate .
Page 16
29.Put on 3 screws. 30.Plug on the power source.
Page 17
31.Put on the front plastic plates and 3 screws, then install 2 protective dust covers.
Page 18
32. Put on 5 screws. 33. As indicated in the picture, put on the screw and the battery, place it back to the console then put on the rubber stands.
Page 19
34.Put on 4 screws, rubber stands and tape. 35.Insatallation finished.