Page 1
IP Touch 4028 IP Touch 4038 IP Touch 4068 Connection: Connect the MSH connection cable to the base of the Jabra GN912x EHS as follows: 2 modular plugs (RJ10+RJ45) 2-sided end: Insert the RJ45 into the socket identified with "AUX" and the RJ10 into the socket identified with the “phone”...
Page 2
The adjustment controller on the base must be set to "A". EHS setup: The Jabra GN912x must support and be set up on MSH EHS. You can check or set it up as follows: 1. Place the headset on the base.
Page 3
3. You can now increase the microphone volume with PLUS or decrease the volume with MINUS. 4. To confirm, after approx. 15 seconds a low signal tone sounds in the https://www.jabra.ca/supportpages/jabra-gn9125/9129-808-215/faq/d8f5ef13-c0f4-4e7a- Page 3 of 5 99c5-558f443e1d45...
Page 4
Menu > Settings > Phone > Internal/External > other options No tone, Progressive, Bleep tones > all items must be set to "OFF". Calls over the headset can be connected/forwarded as follows: https://www.jabra.ca/supportpages/jabra-gn9125/9129-808-215/faq/d8f5ef13-c0f4-4e7a- Page 4 of 5 99c5-558f443e1d45...
Page 5
Dial phone number > the following now appears in the phone display "transfer" > now press the appropriate function button next to the phone display > when connected you must now end the call using the button identified with the "handset". https://www.jabra.ca/supportpages/jabra-gn9125/9129-808-215/faq/d8f5ef13-c0f4-4e7a- Page 5 of 5 99c5-558f443e1d45...