Turning On The Patchmix Wave Send - E-Mu 404 Tutorials Manual

Tutorials
Steinberg WaveLab Lite

2 - Turning on the PatchMix WAVE Send

WaveLab Lite interfaces with PatchMix DSP using WAVE audio instead of ASIO. A WAVE
Send is included in the PatchMix Product Default session. You just have to turn it on.
This is the setup you'll use with any application that uses WAVE instead of ASIO.
Open PatchMix
Left-click once on the E-MU
1.
DSP mixer window appears.
Make sure that the Product Default session is loaded. This session is easily recog-
2.
nized by the presence of TWO Sends in the Aux 1 section (yellow box below).
• If the Product Default session is NOT selected, click once on the Open Session
button and select "Product Default" from the list.
Supply Audio to PatchMix
Connect your audio source to either or both inputs on the Digital Audio System.
3.
Verify that you have meter activity on the channel.
Turn up the Aux Send 1 Amounts
Turn up the Aux Send 1 Amount on the input channel(s) you are using. In the
4.
screen above, signal is coming in on both I/O Card L and I/O Card R, and the Aux 1
amounts are turned up all the way to 0.0dB, as shown by the arrows.
Notice the Send highlighted above in yellow. The TV screen shows this to be a
5.
WAVE Send. By turning up the Aux 1 Amount, you routed the signal to the Aux 1
bus and then out the WAVE Send.
16
icon on the Windows System Tray. The PatchMix
f The TV screen shows
the details of whichever
insert you click on. In the
example at left, the Insert
Send highlighted in
yellow is shown is the TV
screen.
This example shows
how to use a stereo input
— the pan controls are
panned hard left and
right. If you're using a
mono input, set the span
control to center.
Creative Professional