Sony HT-7200DH Operating Instructions Manual page 15

Installing the speakers on the
wall
You can install your surround speakers on the
wall.
1
Prepare screws (not supplied)
that are suitable for the hook on
the back of each speaker as
shown in the illustrations
below.
more than 1 inch (25 mm)
3/16 inch
(4.6 mm)
13/32 inch
(10 mm)
Hook on the back of the speaker
2
Fasten the screws to the wall.
The screws should protrude
7/32 to 9/32 inch (5 to 7 mm).
7/32 to 9/32 inch
(5 to 7 mm)
3/16 inch (4 mm)
3
Hang the speakers on the
screws.
Hook on the back of the speaker
Notes
• Use screws that are suitable for the wall material
and strength. As a plaster board wall is especially
fragile, attach the screws securely to a beam and
fasten them to the wall. Install the speakers on a
vertical and flat wall where reinforcement is
applied.
• Contact a screw shop or installer regarding the wall
material or screws to be used.
• Sony is not responsible for accident or damage
caused by improper installation, insufficient wall
strength or improper screw installation, natural
calamity, etc.
3/16 inch
(4.6 mm)
13/32 inch
(10 mm)
15 US