Warranty Transfer - Nokia NSW-6 Series Disassembly & Troubleshooting Instructions

PAMS Technical Documentation

Warranty transfer

Items:
1 Warranty Cable
2 Flash Adapter
The Warranty cable XMS–3 and 2 pcs Flash adapters FLA–9 are used to
connect two phones and transfer the warranty data (user settings and se-
rial numbers) from one phone to another. The warranty transfer proce-
dure is described below:
Point of Sale
– Phone 1 is broken and Phone 2 is the swap phone.
– Number the phones 1 and 2 to avoid mix–up.
– Plug the warranty cable XMS–3 between the flash adapters and con-
nect the adapters to the phones 1 and 2. (in place of the phone battery)
– Turn the phone 2 on and then on Silent Profile
– Start the warranty data transfer by selecting code *#92772689# in phone
2.
– Select option "Transfer user data?" and press OK, "Confirm transfer?"
Press OK.
– Wait untli the transfer is completed.
– Turn Phone 2 off, then back on and check welcome note and profile.
– After the transfer check with WinTesla the original and warranty ESN of
the phone 2.
– Send the broken phone no.1 to the central service.
Service Center
– Check and repair the phone .
– Change Warranty State from "defective" to "exchange".
– Win Tesla and PKD–1CS are needed
– Menu: Software –> Warranty Info –> Info State –> select "Exchange"
– Send the repaired phone to the dealer.
Point of Sale
– Use the returned phone as a swap phone.
– When the Warranty Info is transferred into a swap phone the Warranty
State changes to USE mode.
– Send the broken phone to the central service.
Issue 1 12/99
Service accessories: Product codes:
XMS–3
FLA–9
E Nokia Mobile Phones Ltd.
Disassembly & Troubleshooting
0730174
0770187
NSW-6
Page 51