Cisco Catalyst 9200 Configuration Manual page 50

Configuring MAC Threshold Notification Traps
DETAILED STEPS
Command or Action
Step 1 enable
Example:
Device> enable
Step 2
configure terminal
Example:
Device# configure terminal
Step 3 snmp-server host host-addr {traps | informs} {version
{1 | 2c | 3}} community-string notification-type
Example:
Device(config)# snmp-server host
172.20.10.10 traps private
mac-notification
Step 4
snmp-server enable traps mac-notification threshold
Example:
Device(config)# snmp-server enable traps
mac-notification threshold
Step 5 mac address-table notification threshold
Example:
Device(config)# mac address-table
notification threshold
Step 6 mac address-table notification threshold [limit
percentage] | [interval time]
Example:
System Management Configuration Guide, Cisco IOS XE Gibraltar 16.10.x (Catalyst 9200 Switches)
36
Purpose
Enables privileged EXEC mode. Enter your password if
prompted.
Enters the global configuration mode.
Specifies the recipient of the trap message.
• host-addr Specifies the name or address of the NMS.
• traps (the default) Sends SNMP traps to the host.
• informs Sends SNMP informs to the host.
• version Specifies the SNMP version to support.
Version 1, the default, is not available with informs.
• community-string Specifies the string to send with
the notification operation. You can set this string by
using the snmp-server host command, but we
recommend that you define this string by using the
snmp-server community command before using the
snmp-server host command.
• notification-type Uses the mac-notification keyword.
Enables MAC threshold notification traps to the NMS.
Enables the MAC address threshold notification feature.
Enters the threshold value for the MAC address threshold
usage monitoring.
Administering the Device