Cisco Catalyst 9200 Configuration Manual page 110

Configuring the Call Home Service for Cisco Smart Software Manager On-Prem
10.
11.
12. exit
13. ip http client source-interface interface-type interface-number
14. crypto pki trustpoint name
15. revocation-check none
16. end
17.
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Device> enable
Step 2 configure terminal
Example:
Device# configure terminal
Step 3
call-home
Example:
Device(config)# call-home
Step 4 no http secure server-identity-check
Example:
Device(config-call-home)# no http secure
server-identity-check
Step 5
profile name
Example:
Device(config-call-home)# profile test1
Step 6 reporting smart-licensing-data
Example:
Device(config-call-home-profile)# reporting
smart-licensing-data
Step 7
destination transport-method http
Example:
Device(config-call-home-profile)# destination
transport-method http
Step 8 destination address http url
Example:
System Management Configuration Guide, Cisco IOS XE Gibraltar 16.10.x (Catalyst 9200 Switches)
96
active
exit
copy running-config startup-config
Purpose
Enables privileged EXEC mode.
Enter your password if prompted.
Enters global configuration mode.
Enters Call Home configuration mode.
Disables server identity check when HTTP connection is
established.
Enters Call Home destination profile configuration mode
for the specified destination profile name. If the specified
destination profile does not exist, it is created.
Enables data sharing with the Call Home service via HTTP.
Enables the HTTP message transport method.
Configures the destination URL (CSSM) to which Call
Home messages are sent.
Note
Configuring Smart Licensing