Draytek Vigor 2800 Quick Start Manual page 24

WEP/802.1x or
WPA/802.1x
WPA/PSK Only
WPA/802.1x Only
3. For WPA encryption, type in 8~63 ASCII characters or 64 Hexadecimal digits
leading by 0x, for example "0123456789ABCD...." or "0x321253abcde....." on the
field of Pre-Shared Key (PSK). WPA encrypts each frame transmitted from the
radio using the Pre-Shared Key (PSK) which entered from this panel.
4. As to WEP encryption, select 64-bit or 128-bit as the encryption mode. For 64bits
WEP key, type in 5 ASCII characters or 10 hexadecimal digitals leading by 0x, for
example, ABCDE or 0x4142434445. And for 128bits WEP key, type in 13 ASCII
characters or 26 hexadecimal digits leading by 0x, for example, ABCDEFGHIJKLM
or 0x4142434445464748494A4B4C4D. Only one WEP key can be selected and
allows user to type in the characters.
5. Click OK to save settings.
Be aware that for the communication, all wireless devices must support the same
encryption bit length and share the same key. If WEP mode is selected, only one of four
preset keys can be selected at one time.
Accept WEP or WPA clients with 802.1x authentication.
Remember to select WPA type to define either Mixed or
WPA2 only in the field below. Since the key will be
auto-negotiated during authentication, the field of key
setting below will be not available for input.
Accepts WPA clients and the encryption key should be
entered in PSK. Remember to select WPA type to define
either Mixed or WPA2 only in the field below.
Accept WPA clients with 802.1x authentication. Remember
to select WPA type to define either Mixed or WPA2 only in
the field below. Since the key will be auto-negotiated
during authentication, the field of key setting below will be
not available for input.
20