Table of Contents
Advertisement
Preparations
Connections
Be sure to use the tool board (J-2500-222-1) to connect to this unit.
Connect the power supply, connect the tool board to the unit, and connect
the terminals of the tool board to the personal computer, TV, or VCR equipped
with an S-Video input. Some connections may require extra cables. Refer to
the instructions manual of the equipment to be connected.
S-VIDEO cable
(not supplied)
to S VIDEO OUT
VISCA cable
(not supplied)
to VISCA IN
Input/Output Conversion board
J-2500-222-1
AC power adaptor AC-EV2
(not supplied) (for PCS-C150)
to DC IN 13.5V
AC power adaptor AC-EV3
(not supplied) (for PCS-C150P)
* When the video camera is connected to a personal computer with a VISCA
cable, you can operate the video camera with the personal computer.
If you have a personal computer or video equip-
ment with the S-Video input
You can connect it to your Color Video Camera with a commercially avail-
able S-video cable.
Notes
• You cannot connect your Color Video Camera to a personal computer
that is not equipped with S-Video input jack.
And you might not be able to use your existing personal computer with
your Color Video Camera unless you provide the computer with a video
capture board and/or software.
Consult your computer dealer or manufacturer for details.
• To supply power to the tool board, use only the AC power adaptor that
has plug of EIAJ type 4 (not supplied). Do not use any other AC power
adaptor.
Polarity of the plug
to S-VIDEO input
*
Personal computer,
TV or VCR with an
audio/video input
jack
to RS-232C
to AC outlet
• Do not grasp the camera head when carrying the video camera.
• Do not turn the camera head manually. Doing so will result in the camera
malfunctioning.
Installation
Be sure to place the main unit on a flat surface.
Turning on the Power
When the tool board is connected to this unit and power is supplied to the
tool board, it will set into the POWER ON state and the camera will auto-
matically face toward the lower right-hand side and then the front, which is
the home position of the camera. (Pan/tilt reset action)
If the lamp at the side of the lens flashes umber
The micro computer inside the camera might not memorize the current
pan/tilt position properly. Use Reset command to reset the pan/tilt position.
PCS-C150/C150P is controlled by VISCA communication.
Refer to VISCA COMMAND LIST.
1-2
E
Input/Output
Conversion board
Flashes.
Advertisement
Table of Contents
