TP-Link TL-WA801ND Setup

Hide thumbs Also See for TL-WA801ND:

Download this manual

1. Attach the included two antennas to the back of the access point. Ensure the connections

are not loose.

2. Power the TP-Link TL-WA801ND using the barrel jack or PoE (Power-over-Ethernet)

injector, and connect a computer to the access point using an Ethernet cable (if using the

PoE injector, connect the LAN port to your computer, and the POE port to the access

point).

3. Ensure all wireless interfaces are disabled on the computer (such as WiFi and Bluetooth)

and that DHCP is enabled on the Ethernet interface. Open a web browser and access the

TL-801ND by visiting

http://tplinkap.net/

4. Log in using username admin and password admin and choose Login.

5. Click Quick Setup from the left side, then Next.

6. Change the admin password if desired and choose Next.

7. Choose Client as the operation mode and press Next.

at http://www.tp-

available

here. Please visit TP-

Page 1 TP-Link Access Point Setup (TL-WA801ND) The TP-Link TL-WA801ND is a multi-function access point. This document is intended to assist with configuring the TL-WA801ND to allow the EG3000 to communicate on an existing WiFi network. This guide is designed only for use with a TP-WA801ND purchased through eGauge Systems For full documentation and other support issues, please visit the TP-Link website at http://www.tp-...
Page 2 I cannot access the configuration interface. Perform a factory reset on the TP-Link access point by using a paperclip or pin and holding down the recessed reset button on the back of the unit, release the button when all the LEDs turn off or flash.
Page 3 Updated Wed, Mar 4, 2020 7:57 PM by Andrew...