Table of Contents
Advertisement
1.
REMOVAL OF MECHANICAL PARTS
AND P.C. BOARDS
1-1:
TOP CABINET/FRONT CABINET/OPERATION PCB
(Refer to Fig. 1-1)
Remove the 5 screws 1.
1.
2.
Remove the Top Cabinet in the direction of arrow (A).
3.
Disconnect the following connector: (CP651).
Unlock the 8 supports 2.
4.
5.
Remove the Front Cabinet in the direction of arrow (B).
Remove the 2 screws 3.
6.
7.
Remove the Operation PCB in the direction of arrow (C).
1
Front Cabinet
(B)
2
2
2
2
2
2
2
1-2: FLAP (Refer to Fig. 1-2)
1.
Open Flap to 90˚ and flex in direction of arrow (A), at
the same time slide in direction of arrow (B).
2.
Then lift in direction of arrow (C).
(C)
DISASSEMBLY INSTRUCTIONS
Top Cabinet
1
1
(A)
1
3
3
(C)
Operation PCB
2
(A)
(B)
Flap
1-3: DVD DECK/DVD PCB (Refer to Fig. 1-3)
1.
Make the short circuit on the position as shown Fig. 1-3
using a soldering. If you remove the DVD Deck with no
soldering, the Laser may be damaged.
Unlock the support 1 and remove the Deck Top Holder
2.
in the direction of arrow (A).
Remove the 2 screws 2.
3.
Remove the 2 screws 3.
4.
5.
Disconnect the following connectors:
(CP501, CP8001).
6.
Remove the DVD Deck in the direction of arrow (B).
Remove the 2 screws 4.
7.
8.
Remove the DVD PCB in the direction of arrow (C).
Remove the 3 screws 5.
9.
10.
Remove the Front Angle in the direction of arrow (D).
1
Fig. 1-1
5
5
NOTE
When the installation of the DVD Deck, remove all the
soldering on the short circuit position after the connection
of Pick Up PCB and VCR PCB connector.
Fig. 1-2
B1-1
4
4
DVD Deck
3
Deck Top Holder
2
1
2
(A)
(B)
5
(D)
Front Angle
DVD PCB
Pick Up PCB
(C)
3
Make the sort circuit
using a soldering.
Fig. 1-3
Advertisement
Table of Contents
