Cub Cadet ENDURO XT Series Operator's Manual page 4

6. Check the safety interlock system per the interval in the Maintenance
Schedule for proper function, as described later in this manual. If the safety
interlock system does not function properly, have your tractor serviced
immediately by an authorized dealer.
7. Never tamper with the safety interlock system or other safety devices. Check
their proper operation regularly.
8. Check the blade(s) mounting bolt torque in accordance to the Maintenance
Schedule in this manual. Also, visually inspect blade(s) for damage (e.g.,
excessive wear, bent, cracked). Replace the blade(s) with the original
equipment manufacturer's (O.E.M.) blade(s) only.
9. Use of service parts which do not meet the original equipment specifications
may lead to improper performance and compromise safety.
10. Keep all nuts, bolts, and screws tight to be sure the equipment is in safe
working condition. Review the Maintenance Schedule chart in this manual
for service interval information.
11. After striking a foreign object, stop the tractor, push the Start/Stop button,
and remove the key. Thoroughly inspect the tractor for any damage. Repair
the damage before operating.
12. To reduce fire hazard, keep the motor(s) free of grass, leaves, and debris
build-up. Follow the post operation tractor care instructions in the Service
and Maintenance section.
13. Check brake operation frequently as it is subjected to wear during normal
operation. Adjust and service as required.
14. Never attempt to make adjustments or repairs to the tractor without
removing the key.
15. Maintain or replace safety and instruction labels, as necessary.
General Electric Safety
1. Do not expose the tractor to rain or wet conditions.
2. Do not service the tractor or handle electrical components with wet hands.
3. Do not operate the tractor in the rain, in wet conditions, or on wet surfaces.
4. To reduce the risk of electric shock, avoid body contact with grounded
conductors, such as metal pipes or wire fences.
5. Do not operate the tractor in explosive atmospheres, such as in the presence
of flammable liquids, gases, or dust.
6. For protection against risk of injury or electric shock, do not replace blown
fuses. Your tractor should be serviced professionally by an authorized dealer.
7. Never douse or spray the tractor with water. Avoid getting any liquid in the
motors and electrical connections. Clean the tractor after each use. Refer to
Service and Maintenance. Do not use solvents or strong detergents.
Battery Charger Safety
WARNING
Only use an OEM battery charger to charge the batteries in this tractor.
Do NOT attempt to charge any other batteries with the battery charger
specific to this tractor. Other types of batteries may burst, causing fire,
personal injury, or property damage.
1. Recharge only with the charger specified by the manufacturer. A charger
that is suitable for one type of battery may create a risk of fire when used
with another battery.
2. Do not use the charger in the rain, wet locations, or in the presence of
flammable liquids or gases.
3. A nameplate on the charger indicates the voltage used. Never connect the
charger to an AC voltage that differs from this voltage.
SAFE OPERATION PRACTICES
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
17.
Battery Safety
1.
2.
3.
4.
5.
6.
7.
4
An extension cord should not be used unless absolutely necessary. Use
of an improper extension cord could result in a risk of fire, electric shock,
or electrocution.
Do not use multiple extension cords.
Make sure the extension cord is heavy enough to carry the current drawn by
the charger. An undersized extension cord will cause a drop in line voltage,
resulting in a loss of power and overheating. If in doubt, use the next heavier
gauge cord. The smaller the gauge number, the heavier the cord.
MINIMUM WIRE SIZE FOR EXTENSION CORDS
FOR 120 VOLT APPLIANCES USING 0-6 AMPS
Cord Length (ft.) 25
Wire Size (AWG) 16
Make sure the cords are in good condition. Inspect the battery charger power
cord and extension cord periodically. Look closely for deterioration, cuts,
or cracks in the insulation. If either cord is damaged in any manner while
plugged in, disconnect the cord from both the outlet and the charger. Do not
use a damaged cord. Damaged cords should be repaired or replaced.
Do not abuse cords. Never pull or carry the charger by a cord. Keep cords
away from heat, oil, water, sharp edges, and moving objects. Always grasp
the plug when disconnecting a cord.
Never modify a plug, cord, or outlet in any way.
Ground Fault Circuit Interrupter (GFCI) protection should be provided on the
circuit(s) or outlet(s) to be used with this charger. For an extra measure of
safety, use receptacle (outlet) with built-in GFCI protection.
Do not place the battery charger where cords might be stepped on, tripped
over, or subjected to damage.
Keep the battery charger and cords in a cool and dry area.
Keep the battery charger and cords away from all liquids.
Do not allow small metal items or material such as steel wool, aluminum foil,
or other foreign particles into the charger port.
Do not probe the charger with conductive material. There is a risk of
electric shock.
Do not cover the battery charger. The battery charger may overheat.
Do not allow the battery or battery charger to overheat. If they are warm,
allow them to cool down. Only charge batteries in temperatures between
32° and 104° F (0° and 40° C).
Do not expose the battery to fire or to temperatures over 140° F (60° C).
Doing so could cause an explosion.
Handle battery with care. Do not short the battery with conductive
materials, such as rings, bracelets, keys, etc. Shorting the battery may cause
personal injury, damage to the battery, or a fire.
Do not attempt to charge a cracked or damaged battery.
Do not use or charge a wet battery or a battery that shows any evidence
of corrosion.
Do not use a damaged or modified battery. Doing so could result in a fire,
explosion, or personal injury.
Do not dispose of the battery in a fire. The cell may explode. Contact your local
authorized service dealer for proper battery recycling.
Exercise care in handling batteries in order not to short the battery with
conductive materials such as rings, bracelets, and keys. The battery or
conductor may be hot and cause burns.
50 100 150
16 16 14