LG WT17DSBP Service Manual page 43

1 1 ) S pi n i n g is g o in g o n e v e n t h o u g h t h e l id is o pe n .
Where, what & how to check?
Ball Pressure Sensor
1. Is placed the magnetic on the wash?
12) S pin ba sk e t do e s n ' t re a ch t o f u ll spe e d ( n o r m a l r pm )
Where, what & how to check?
Main voltage
1. Check voltage at the power outlet
where the washer is plugged into.
Clutch Assembling
1. Check the clearance between the
PV link and the brake lever and
clearance between the clutch lever
and the adjustment bolt.
Blocked by foreign objects
1. Check whether the PV asm, the
drain pump & the drain hose are
blocked by foreign objects so that it
makes water-splashing noise in the
tub.
Result of Check Possible Cause
Reed S/W is short
by magnetic on
Yes
the washer.
Reed Switch.
No
Result of Check Possible Cause
Less than Tool low voltage
85% of rating
The clearance is
less than 2.0 mm
or more than 3.5 mm
Bolt clearance is
Defect of the
out of range
clutch
1.9 0.1mm
43
How to repair & settle
Keep magnet away from
the washer.
Change the controller.
How to repair & settle
Explain the cause and
recommend using a
transfomerformer if
necessary.
Adjust PV lever bolt and
paint it red.
Reassemble the drain
motor or the clutch.
Adjust the bolt
clearance.
Remove the foreign
objects.
Copyright © 2017 LG Electronics Inc. All rights reserved.
Only training and service purposes.