LG WT17DSBP Service Manual page 42

10) S pin e x t r a ct io n is n o t pro ce e d e d .
Where, what & how to check?
Motor
1. In the case that the wash motor does not
spin during spin extraction;
1) Check there is motor working
sound,or
2) If there is no motor-working
sound;
Check frequency of the
Ball Pressure Sensor
(Pressure Switch), under no load,
or
Is placed the magnetic in Lid-B.
Check resistance of the motor.
Drain Motor/Clutch
1. In the case the motor rotates but the
inner tub does not rotates;
1) Check resistance of the drain
motor if the drain motor doesn't
work,or
2) Check gap between the PV link
and the brake lever if the inner
tub does not rotates while the
drain motor works.
Result of Check Possible Cause
There is motor Mechanically
locked.
working sound.
Defect of the
Less than
Ball Pressure
26.3
Sensor(Pressure
Switch).
Mistake in use.
The lid is open.
Defect of magnetic in
LID-B
Contact defect of
the Ball Pressure
Sensor.
Coil is open.
Resistance is
Coil is open.
normal
Defect of
connection part or
defect of the
controller.
The clearance is
Assembling defect
less than 2.0mmor
of the drain motor or
more then 3.5mm
the clutch
The gap is normal
Defect of the clutch.
(2.0~3.5mm)
42
How to repair & settle
Check whether the
washing clutch or the
washing tub is blocked
if the motor rotates after
removing the V-belt.
Check whether the
motor is locked if the
motor does not rotates
even though the V-belt
being removed.
Change the Ball Pressure
Sensor(Pressure Switch).
Explain"The lid is close
during operation"
Change the Lid-B
Change the Ball Pressure
Sensor.
Change the motor.
Change the drain motor.
Change the controller after
checking connection parts.
Reassemble the drain
motor or the clutch to
keep the clearance.
Change the clutch.
Copyright © 2017 LG Electronics Inc. All rights reserved.
Only training and service purposes.