Plug Replacement - Stanley ST-02-230-E Instruction Manual

NEVER LEAVE HEATER UNATTENDED WHILE
CONNECTED TO A POWER
WARNING
NOTE: This section only applies to heaters sold or used in Great Britain.
This appliance is supplied with a BS1363 3
pin plug fitted with a fuse. Should the fuse
require replacement, it must be replaced
with a fuse with the proper amp rating.
(see Technical Specifications page 5) and
approved to BS1362.
NOTE: Heater models ST-02-230-E and ST-
02-240-E, sold in the UK, use 13A fuse with
BS1363 three pins plug only.
In the event the mains plug has to be
removed/ replaced for any reason, please
note:
IMPORTANT: The wires in the mains
lead are colored in accordance with the
following code:
Blue – Neutral Brown – Live
Green/Yellow – Earth
As the colors of the wires in the mains
lead of this appliance may not correspond
Plug Replacement Wiring Diagram
© 2021, Obelis S.A. Registered Address:
Bd. Général Wahis, 53, 1030 Brussels, Belgium

Plug Replacement

RISK OF ELECTRIC SHOCK! DISCONNECT FROM
POWER BEFORE MAINTENANCE.
BLUE
Neutral
CORD CLAMP
SOURCE
with the colored markings identifying the
terminals in your plug, proceed as follows:
The blue wire must be connected to the
terminal marked with an N or colored
black. The brown wire must be connected
to the terminal marked with an L or
colored red. The green/ yellow wire must
be connected to the earthing terminal
which is marked with an E or with the
earth symbol.
WARNING
wires to the earth terminal of
the plug.
NOTE: If a moulded plug is fitted and
has to be removed take great care in
disposing of the plug and severed cable,
it must be destroyed to prevent engaging
into a socket.
GREEN / YELLOW
Earth
11
Never connect
live or neutral
BROWN
Live
FUSE
13 Amps