Plug Replacement - Stanley ST-02-230-E Operating Instructions Manual

NEVER LEAVE HEATER UNATTENDED WHILE CONNECTED TO A POWER SOURCE
WARNING
RISK OF ELECTRIC SHOCK! DISCONNECT FROM POWER BEFORE MAINTENANCE.
NOTE: This section only applies to heaters sold or used in Great Britain.
This appliance is supplied with a BS1363 3 pin
plug fitted with a fuse. Should the fuse require
replacement, it must be replaced with a fuse
with the proper amp rating. (see Technical
Specifications page 2) and approved to BS1362.
In the event the mains plug has to be removed/
replaced for any reason, please note:
IMPORTANT: The wires in the mains lead are
colored in accordance with the following code:
Blue – Neutral
Green/Yellow – Earth
As the colors of the wires in the mains lead of this
appliance may not correspond with the colored
markings identifying the terminals in your plug,
proceed as follows:
© 2015, Pinnacle Products International Inc

Plug Replacement

Brown – Live
Plug Replacement Wiring Diagram
BLUE
Neutral
CORD CLAMP
.
The blue wire must be connected to the terminal
marked with an N or colored black. The brown
wire must be connected to the terminal marked
with an L or colored red. The green/ yellow wire
must be connected to the earthing terminal which
is marked with an E or with the earth symbol.
WARNING
the plug.
NOTE: If a moulded plug is fitted and has to
be removed take great care in disposing of the
plug and severed cable, it must be destroyed to
prevent engaging into a socket.
GREEN / YELLOW
Earth
6
Never connect live or neutral
wires to the earth terminal of
BROWN
Live
FUSE
13 Amps