Installation - Denon DCM-5000 Operating Instructions Manual

ENGLISH
6

INSTALLATION

Removing the Shipping Screws
The internal mechanisms are locked in place with shipping
screws to protect them from shocks and vibrations. Be sure to
remove the shipping screws (three) before using the player.
1
Turn the three shipping screws on section A of the rear
panel counterclockwise and remove them.
Fasten the removed shipping screws in the holes in section
2
B.
* The shipping screws and rubber washers will be
needed when shipping the player in the future, so be
sure to fasten them to the holes in section B so as
not to lose them.
[When moving the player]
When shipping the player, be sure to protect the internal
mechanisms from shocks and vibrations using the procedure
described below.
1 Remove all the CDs from the disc rack following the
procedure described under "Loading CDs" (page 9).
Close the front cover.
2
DISC" appears on the display once all the CDs
• "NO
have been removed.
3 Press the power operation switch (
turn the power off.
Press the power operation switch (
4
pressing in the DOOR OPEN button to turn the power on.
Do not release the DOOR OPEN button until "FIX
SCREW" appears on the display.
Once "FIX SCREW" appears on the display, remove the
5
three shipping screws from section B of the rear panel, put
them in the holes in section A, then tighten them to lock
the internal mechanism in place.
Press the power operation switch (
6
turn the power off.
MODE Switch Settings
There are mode switches on the rear panel for setting the
operation mode. Set the mode switches according to the usage
purpose.
0 To control with a personal computer.
SW 1
1 To use in the stand alone mode.
0
SW 2
1
0
These do not affect the DCM-5000's operation
SW 3
mode.
1
0
SW 4
1
* When SW 1 is set to "0", the only operations possible on the DCM-
5000 are turning the power on and off and opening the door.
Upon shipment from the factory, SW 1 is set to "1" and all the other
switches are set to "0".
8
ON/STANDBY) to
¢
ON/STANDBY) while
¢
ON/STANDBY) to
¢
Section
A
q
Shipping screws
Section
A
t
Shipping screws
1
DAISY CHAIN IN
DIGITAL COAX IN
2
1
ATTENTION
DIGITAL COAX OUT
2
ANALOG OUT
1
VIDEO OUT
2
REMOTE CONTROL IN
R L
1 0
DAISY CHAIN
CONTROL
1 0
MODE SWITCH
EXTERNAL
CONTROL ¢ RS232C
RS422A
£
Section
B
w
Section
B
ATTENTION