Adjusting the inclination
The inclination of the monitor can be adjusted by - 5° (forward) and +25°
(back) from its vertical position.
► Hold the monitor with both hands on the left and right sides of the casing and move
it to the desired angle (see
Adjusting the rotation
The monitor can be rotated by ±172°.
► Grasp the monitor with both hands on the right and left edge of the casing
and turn it to the desired position.
Removing monitor base
Before you can use a swivel arm or a similar accessory, you must remove the monitor base.
The display surface is susceptible to scratching!
Place the device on a stable, flat and clean surface. If necessary, place a slip-resistant
cloth on this surface to prevent the device from being scratched.
1
1
For instructions on how to mount the swivel arm or a similar accessory, please
see the documentation for the swivel arm or similar accessory.
The assured ergonomics and safety of the monitor may be limited if the
foot provided for the monitor is not used.
Fujitsu
"Adjusting height", Page
► Switch off the monitor and pull the power
► Lay the monitor on its face on a soft surface.
► Disconnect all cables.
► To release the stand, remove the four
1
1
16).
plug out of the power socket.
screws (1) that hold the stand in the VESA
mount. Then lift the stand away upwards.
You can now mount a swivel arm or a
similar accessory in accordance with VESA
FPMPMI using a hole spacing of 100 mm.
Getting started
17