Fujitsu P34-9 UE Operating Manual page 35

If the selected input signal does not deliver an image, the monitor
shall change this automatically.
In the following cases an automatic change of the input signal is disabled:
• When the "Daisy-Chain" function is activated.
• When the input signal to the "USB-C" monitor port is chosen.
Press the button
is not displaying an image and is in power-saving mode.
If on the USB-C upstream port a sheer USB data connection is detected, an
enlarged setting window will be displayed.
► Press the /
► Press the /
video signal.
The built-in KVM will be switched based on the assignments set.
For further information on the KVM function, please refer to chapter
"Notes about the KVM function", Page
Fujitsu
► Press the
► Press the /
► Press the button to confirm the selected monitor port or
the window without making any changes.
To call up the INPUT settings window if the monitor
INPUT / USB UPSTREAM
HDMI1
HDMI2
DisplayPort
USB-C
buttons to select the desired monitor port.
buttons to change the assignment of the USB upstream to the relevant
button to open the INPUT setting window.
button to select the desired monitor port.
USB-B
USB-B
USB-B
USB-C
48.
Operation
to close
31