Denon DVD-2200 Operating Instructions Manual page 12

ENGLISH
(3) Connecting to a AV amplifier with a built-in decoder
When DVDs recorded in Dolby Digital or DTS are played, Dolby Digital or DTS bitstream signals are output from the DVD player's digital audio
output connectors. If a Dolby Digital or DTS decoder is connected, you can achieve sound with the power and sense of presence of a movie
theater or concert hall.
The same data is output from both digital audio output connectors
(COAXIAL and OPTICAL). Connect to one or the other connector,
according to your system.
DVD-2200
Front speaker (left)
Surround speaker (left)
NOTES:
• Harsh noise that could harm your ears or damage the speakers is generated when a DVD recorded in DTS is played while using a
decoder, etc., that is not DTS-compatible.
• When playing copyright-protected linear PCM or packed PCM DVDs, in consideration of copyrights, no digital signals are output for
sources exceeding 48 kHz/16 bits. When playing such sources, either set "LPCM (44.1 kHz/48 kHz)" under "AUDIO SETUP" at
"SETUP" to "ON" (see page 33) or make analog connections. (See page 14.)
• When making digital connections to an AV amplifier that is not compatible with 96 kHz/88.2 kHz signals, set "LPCM (44.1 kHz/48 kHz)"
under "AUDIO SETUP" at "SETUP" to "ON". (See page 33.)
• With Super audio CDs, digital audio signals cannot be output. Use analog connections. (See page 14, 15.)
12
Optical fiber cable 75 /ohms pin-plug
(commercially cable (commercially
available) available)
Digital audio input Digital audio input
connector (OPTICAL) connector (COAXIAL)
SURROUND MODE
DOLBY DTS WIDE 5CH / 7CH DSP
DIRECT STEREO SURROUND SURROUND SCREEN STEREO SIMULATION
PHONES
CINEMA / 6.1 / 7.1 VIDEO TONE
INPUT
MODE ANALOG EXT. IN MUSIC SURROUND ON / OFF DEFEAT
INPUT
AV amplifier with a built-in decoder
(AV control center)
To power outlet
Center speaker
Front speaker (right)
Subwoofer
Surround speaker (right)
MULTI FUNCTION
MODE FUNCTION CONTROL
STATUS SELECT
REC /
M-ZONE 1 M-ZONE 2
REC SELECT / M-ZONE