Installing The Bobbin Winder Device; Winding The Bobbin Thread - JUKI PS-800-12080 Instruction Manual

3-4. Installing the bobbin winder device

❶ ❶

3-5. Winding the bobbin thread

LED lamp 1,2,3,4
"+", "-", "P",
Emergency
"<", ">" key
4. Threading Diagram
❷ ❷
❸ ❸
Start
stop
1) Insert bobbin winder disk mounting bar ❶ into
hole ❷ in the bobbin winder and secure with nut
❸ .
1. Button description
1) Red button: emergency stop, press this button for
2 seconds will be reset.
2) Green button: Start
3) "P" key: function key, Hold down "P" key for 2
seconds to enter parameter setting, after setting
is finished, press this key again for 2 seconds to
keep parameter.
4) "+" key: numbers from 0 to 9
5) "-" key: numbers from 9 to 0
6) "<" key: turn left
7) ">" key: turn right
2. Indicator light
1) Parameter indicator light
2) Production failure indicator light
3) Stop indicator light
4) Work indicator light
3. Parameter setting
Hold down "P" key for 2 seconds to enter the param-
eter setting inter face.
A: The thread length setting is 0 to 99.9 meters
B: Compensate for 0 to 9.9 meters
C: The bobbin calculate to thread length 0 to 99.9
meters
D: Motor speed: F1 (fast), F2 (medium), F3 (slow)
E: LED lamp brightness: H0 (OFF), H1 (darkest), H2,
H3, H4, H5 (brightest)
– 11 –