Attaching The Rack Handles; Attaching The Slide-Shoulder Screws; Installing The Rack Handles - Dell PowerEdge 1800 Supplementary Manual

Attaching the Rack Handles

1
Position one rack handle on the side of the chassis so that the handle's pull-loop is nearest the
top of the system. See Figure 1-6.
2
Align the three screw holes on the rack handle with the three screw holes on the side of
chassis.
3
Use three of the hex-head Phillips screws that are supplied with your kit to secure the rack
handle to the chassis.
NOTE:
second, and the middle screw last.
4
Repeat step 1 through step 3 to attach the other rack handle.
Figure 1-6. Installing the Rack Handles

Attaching the Slide-Shoulder Screws

Your kit includes six shoulder screws that enable the system to be attached to rack slides. Attach
three slide-shoulder screws to each side of the chassis. See Figure 1-7.
10
Installing the Tower-to-Rack and Rack-to-Tower Kits
To obtain proper alignment of the rack handle, tighten the top screw first, the bottom screw
pull-loop
rack handles (2)
hex-head Phillips
screws (6)