Preparing The Bubble - Bosch AUTODOME IP starlight 7000i Installation Manual

Hide thumbs Also See for AUTODOME IP starlight 7000i:
Table of Contents

Advertisement

AUTODOME IP starlight 7000i
5

Preparing the bubble

Notice!
i
To avoid excessive moisture saturation inside the housing, limit the amount of time that the
bubble is disconnected from the housing. Bosch recommends that the bubble be removed
from the housing for no more than five (5) minutes.
Remove the bubble from a pendant housing
1.
2.
Figure 5.1: Remove the bubble
4
Bosch Security Systems
Using both hands, apply a firm counterclockwise (looking up at the dome) rotational
force on the pendant bubble assembly to set the bubble latch.
Insert a small (2 mm) straight blade screw driver into the release opening in the bubble
trim-ring to release the lock, and then remove the screwdriver.
Firmly rotate the bubble counterclockwise approximately 20 degrees until the bubble
assembly releases from the pendant housing.
Installation Manual
Preparing the bubble | en
2021-03 | 1.2 |
21

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents