Hardware Troubleshooter; Dell Diagnostics - Dell Studio 1737 Setup Manual

Using Support Tools
No timer tick interrupt — A chip on the system
board might be malfunctioning or motherboard
failure (see "Contacting Dell" on page 55 for
assistance).
USB over current error — Disconnect the USB
device. Your USB device needs more power for
it to function properly. Use an external power
source to connect the USB device, or if your
device has two USB cables, connect both of
them.
NOTICE - Hard Drive SELF MONITORING
SYSTEM has reported that a parameter has
exceeded its normal operating range. Dell
recommends that you back up your data
regularly. A parameter out of range may or may
not indicate a potential hard drive problem —
S.M.A.R.T error, possible hard disk drive failure.
This feature can be enabled or disabled in the
BIOS setup (see "Contacting Dell" on page 55
for assistance).
40

Hardware Troubleshooter

If a device is either not detected during
the operating system setup or is detected
but incorrectly configured, you can use the
Hardware Troubleshooter to resolve the
incompatibility.
To start the Hardware Troubleshooter:
Click → Help and Support.
1. Start
Type hardware troubleshooter in
2.
the search field and press <Enter> to start
the search.
3. In the search results, select the option that
best describes the problem and follow the
remaining troubleshooting steps.

Dell Diagnostics

If you experience a problem with your
computer, perform the checks in "Lockups and
Software Problems" on page 58 and run the
Dell Diagnostics before you contact Dell for
technical assistance.