Dell OptiPlex GXi Reference And Installation Manual page 119

Message
WARNING: Could not
configure Plug and
Play Card Name.
WARNING: Could not
configure PCI device,
ID=DeviceID.
Failed to configure
Number of Total Count
Plug and Play ISA
devices. Use your sys-
tem's configuration
utility to resolve
conflicts. Press any
key to continue.
WARNING: Boot Device
conflict detected!
CSN=Card Select Number
Error=Error.
NOTE: For the full name of an abbreviation or acronym used in this table, see the Glossary in the online System User's Guide.
Table B-2. Configuration Manager Messages
Probable Cause
The card(s) mentioned are
not fully configured due to
resource conflicts.
One of the devices is
attempting to use one or
more resources assigned to
the system's boot device.
(Continued)
Corrective Action
If you do not know the allowable resource val-
ues for your Plug and Play or PCI expansion
card, use the following procedure to locate and
resolve the resource conflict:
1. Remove all card configurations from the
ICU.
See "Removing a Card" in Chapter 3 for
instructions.
2. Reboot your system.
The ICU should automatically configure
your Plug and Play or PCI expansion card.
3. Add the ISA expansion cards back into
the ICU, resolving any resource conflicts
as they arise.
See "Adding a Listed Card" in Chapter 3
for instructions.
If your Plug and Play or PCI expansion card is
not automatically configured when you reboot
the system with all other cards removed, you
should contact the manufacturer of the card or
see the chapter titled "Getting Help" in your
Diagnostics and Troubleshooting Guide.
Perform the following procedure:
1. Start the ICU.
2. Identify the card marked config err.
This should be the card that is attempting
to use one or more resources required by
the system's boot device.
3. Follow the procedure for the preceding
error message in this table.
ISA Configuration Utility Messages B-9