Network Problems - Dell Dimension 9200 Owner's Manual

R E S T A R T T H E C O M P U T E R
1
Simultaneously press <Ctrl><Esc> to display the Start menu.
2
Press <u>, press the up- and down-arrow keys to highlight Shut down or Turn Off, and then press
<Enter>.
3
After the computer turns off, reconnect the mouse cable as shown on the on the setup diagram for your
computer.
4
Turn on the computer.
E S T T H E M O U S E
T — Connect a properly working mouse to the computer, then try using the mouse.
C H E C K T H E M O U S E S E T T I N G S
1
Click Start, click Control Panel, and then click Printers and Other Hardware.
2
Click Mouse.
3
Adjust the settings as needed.
R E I N S T A L L T H E M O U S E D R I V E R
R U N T H E H A R D W A R E
on page 72.

Network Problems

CAUTION:
Before you perform any of the procedures in this section, follow the safety instructions in the Product
Information Guide.
C H E C K T H E N E T W O R K C A B L E C O N N E C T O R
network connector on the back of the computer and the network jack.
C H E C K T H E N E T W O R K L I G H T S O N T H E B A C K O F T H E C O M P U T E R
network communication exists. Replace the network cable. For a description of network lights, see
"Controls and Lights" on page 126.
R E S T A R T T H E C O M P U T E R A N D L O G O N T O T H E N E T W O R K A G A I N
H E C K Y O U R N E T W O R K S E T T I N G S
C
your network to verify that your network settings are correct and that the network is functioning.
58
Solving Problems
—
—
— See "Reinstalling Drivers" on page 71.
T R O U B L E S H O O T E R — See "Resolving Software and Hardware Incompatibilities"
— Ensure that the network cable is firmly inserted into the
— Contact your network administrator or the person who set up
— If the link integrity light is off, no