Dell Dimension 2300 Owner's Manual page 91

Record all the screens in the system setup program (see page 87) so
1
that you can restore the correct settings when your perform step 7.
Open the computer cover (see page 67).
2
Locate the battery socket BATTERY (see page 70).
3
Remove the battery by carefully prying it out of its socket with your
4
fingers or with a blunt, nonconducting object such as a plastic
screwdriver.
NOTICE: To avoid damage to the system board while you pry the battery
loose, be sure to insert the plastic screwdriver between the battery and the
socket (not the system board).
battery socket
(BATTERY)
Insert the new battery into the socket with the side labeled "+" facing
5
up and snap the battery into place.
NOTICE: To connect a network cable, first plug the cable into the network
wall jack and then plug it into the computer.
Connect your computer and devices to electrical outlets, and turn
6
them on.
Access the system setup program (see page 87) and restore the settings
7
you recorded in step 1.
Properly dispose of the old battery (see page 12).
8
battery
91
Appendix