Environmental Protection; Speed Selection; Maintenance And Storage - IVT AG-115S Manual

page of 109

/ 109
Contents
Table of Contents
Bookmarks

Table of Contents

Available languages

Instruction manual

The direction in which one cuts is important.

The machine must always rotate opposite to the

direction of motion; therefore never move the machine

in the other direction! Otherwise, the danger exists that

it will be forced uncontrolled out of the cut.

When cutting profiles or square pipes it is best to start

with the smallest cross section.

SPEED SELECTION

(AG-150H)

With the speed selection thumbwheel (15) the required

speed can be selected (also while running). [F8]

The required speed is dependent on the material and

can be determined with practical trials. After longer

periods of working at low speed, allow the machine to

cool by running for approximately 3 minutes at maximum

speed with no load.

MAINTENANCE AND STORAGE

Before any work on the device itself,

pull the mains plug.

∙

Always keep the tool and the ventilation slots (if present)

cleaned. Regular cleaning and maintenance of the appliance

will ensure efficiency and prolong the life of your tool.

∙

If the tool should fail despite the rigorous

manufacturing and testing procedures, the repair should

be carried out by an authorized IVT customer service.

∙

Keep all nuts, bolts, and screws tight, to be sure the

tool is in safe working condition.

∙

Replace worn or damaged parts for safety.

∙

Use only original spare parts. Parts not produced

by manufacturer may cause poor fit and possible injury.

∙

Store the tool in a dry room out of reach of kids and

away from any flammable material.

∙

Never wet the device or spray water on it!

Cleaning instructions

Maintenance service includes cleaning the machine for

dirt and dust upon termination of work and replacement

of carbon brushes when worn.

∙

Clean the case with a damp cloth and let the tool

dry. It is forbidden to use solvents and other aggressive

substances.