Fault
The door cannot be opened. Rinse Hold
The water is not draining.
Water is not flowing in. De-
tergent is not being dis-
pensed.
Cause
is activated.
The temperature is too high.
Water level is too high.
Power failure.
Drain pipe or water outlet
hose is blocked.
Drain pipe or water drain
hose is caught or jammed.
Drain pump is blocked.
Rinse Hold
is activated.
The water outlet hose is con-
nected too high.
Pump cover is not correctly
assembled.
Pump cover is not correctly
assembled.
You have not pressed Inicio/
Pausa+Carga
.
The filter in the water inflow
is blocked.
The tap is turned off.
Troubleshooting en
troubleshooting
Continue the programme by select-
▶
ing Spin or Drain and pressing Ini-
cio/Pausa+Carga
→ "Resuming the programme when
the programme status is Rinse
Hold", Page 44
Wait until the temperature has
▶
dropped.
→ "Cancelling the programme",
▶
Page 44
Start the Drain programme.
▶
Open the door using the emergency
▶
release.
→ "Emergency release", Page 69
Clean the drain pipe and the water
▶
outlet hose.
Ensure that the drain pipe and wa-
▶
ter drain hose are not kinked or
trapped.
→ "Cleaning the drain pump",
▶
Page 55
Continue the programme by select-
▶
ing Spin or Drain and pressing Ini-
cio/Pausa+Carga
→ "Resuming the programme when
the programme status is Rinse
Hold", Page 44
Install the water outlet hose at a
▶
maximum height of 1 metre.
→ "Technical specifications",
Page 74
Correctly assemble the pump
▶
cover.
Correctly assemble the pump
▶
cover.
Press Inicio/Pausa+Carga
▶
"Clean the water inflow filter"
▶
→ Page 58.
Turn on the tap.
▶
.
.
.
63