Table of Contents
Advertisement
Fault
i-DOS error, deactivate i-
DOS
"E:60 / -2B"
"E:10 / -10"
"E:35 / -10"
All other error codes.
Water cooling
Cause
The pump for the intelligent
dosing system is blocked.
The unbalanced load detec-
tion system has interrupted
the spin cycle because the
laundry is unevenly distrib-
uted.
The filter in the water inflow
is blocked.
The tap is turned off.
The water inlet hose is
kinked or jammed.
There is water in the base
trough.
The appliance is leaking.
Malfunction
To protect the wastewater
pipes, the hot detergent
solution is cooled before be-
ing drained.
Troubleshooting en
troubleshooting
Switch off the appliance.
1.
Clean the pump unit.
2.
→ "Cleaning the detergent drawer",
Page 53
If this indicator appears again, call
3.
our after-sales service.
→ "Customer Service", Page 71
Note: You can start the washing pro-
gramme if you deactivate the intelli-
gent dosing system and dose manu-
ally.
→ "Buttons", Page 26
Redistribute the laundry in the
▶
drum.
Note: Where possible, mix large and
small items in the drum. Different sized
items of laundry distribute themselves
better during the spin cycle.
"Clean the water inflow filter"
▶
→ Page 58.
Turn on the tap.
▶
Ensure that the water inlet hose is
▶
not kinked or jammed.
Turn off the water tap.
▶
Call the after-sales service.
▶
→ "Customer Service", Page 71
Turn off the water tap.
▶
Call the after-sales service.
▶
→ "Customer Service", Page 71
Call the after-sales service.
▶
→ "Customer Service", Page 71
Wait until the detergent solution
▶
has cooled down.
61
Advertisement
Table of Contents
