Replacing The Drive-Bay Heat Sensor Cable; Procedure; Post-Requisites - Dell Alienware Area-51 R5 Service Manual

Replacing the drive-bay heat sensor cable

NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your
inside your computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.

Procedure

1. Route the drive-bay heat-sensor cable through the slot on the chassis.
2. Align the tab on the drive-bay heat-sensor cable on the chassis.
3. Push the release tab on the drive-bay heat-sensor cable and press it into place.
4. Lay the chassis on the left side.
5. Connect the drive-bay heat-sensor cable to the system board. See

Post-requisites

1. Replace the left and right side-panels. See
2. Replace the stability foot.
42
computer. After working inside your computer, follow the instructions in
"Replacing the side panels".
"system-board components".
After working
www.dell.com/