Removing The Drive-Bay Shroud; Replacing The Drive-Bay Shroud - Dell Alienware Area-51 Service Manual

Removing the Drive-Bay Shroud

1. Follow the instructions in "Before You Begin" on page
2. Remove the left side-panel (see "Removing the Left Side-Panel" on page
3. Remove the PCI shroud (see "Removing the PCI Shroud" on page
4. Disconnect the drive-bay shroud cables from the master I/O board
connectors.
5. Remove the two screws that secure the drive-bay shroud to the chassis.
6. Slide and pull the drive-bay shroud away from the computer.

Replacing the Drive-Bay Shroud

1. Follow the instructions in "Before You Begin" on page
2. Align the screw holes on the drive-bay shroud with the screw holes on the
chassis.
3. Replace the two screws that secure the drive-bay shroud to the chassis.
4. Connect the drive-bay shroud cables to the master I/O board connectors.
5. Replace the PCI shroud (see "Replacing the PCI Shroud" on page
6. Replace the left side-panel (see "Replacing the Left Side-Panel" on page
7. Connect your computer and devices to electrical outlets, and then turn
them on.
6.
15).
22).
6.
22).
15).
1 drive-bay shroud
CHAPTER 4: SHROUDS
1
2
2 screws (2)
023
/
023