Removing The Antenna Cables; Prerequisites; Procedure - Dell Alienware Area-51 R5 Service Manual

Removing the antenna cables

NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your
inside your computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.

Prerequisites

1. Remove the stability foot.
2. Remove the left and right side-panels. See
3. Remove the handle bars.
4. Remove the graphics card.
5. Remove the wireless card.
6. Remove the front bezel.
7. Remove the rear bezel.

Procedure

1. Lay the chassis on the right side.
2. Disconnect the antenna cables from the wireless card.
3. Remove the antenna cables from the routing guide on the chassis.
4. Slide the antenna cables through the slot on the chassis.
5. Turn the chassis over.
6. Remove the antenna cables from the routing guide on the chassis.
7. Slide the antenna cable through the slot on the chassis.
computer. After working inside your computer, follow the instructions in
"Removing the side panels".
After working
www.dell.com/
105