Password Setting - HighPoint SSD6540M User Manual

When a physical drive fails, the controller will take the drive
offline. Once you re-insert or replace the disk, the controller will
not automatically rebuild the array unless this option is enabled.
Enable continue rebuilding on error (default: Enabled)
When enabled, the rebuilding process will ignore bad disk sectors
and continue rebuilding until completion. When the rebuild is
finished, the data may be accessible but may also be inconsistent,
due to any bad sectors that were ignored during the procedure. If
this option is enabled, HighPoint recommends checking the event
log periodically for bad sectors warnings.
Restrict to localhost access (default: Enabled)
Remote access to the controller will be restricted when enabled;
other users in your network will be unable to remotely log in to
the HRM.
Set Rebuild Priority (default: Medium)
You can specify the amount of system resources you want to
dedicate to rebuilding the array. There are 5 levels of priority
[Lowest, Low, Medium, High, Highest]
Port Number (default: 7402)
The default port that the HighPoint HRM listens on is 7402.
You may change it to any open port.

Password Setting

Changing your HRM password
21