Dismantling The Ignition Module And Flywheel - Husqvarna 120 Workshop Manual

Repair Instructions
7.5 Dismantling the ignition module
and flywheel
1
Remove the cylinder cover. Remove the starter.
Snap off the ignition cable from the air guide plate
and remove the air guide plate. See figure 9.
2
Knock out a few of the pins in the tool if it does not
match up with the flywheel. Use a piston stop (575
29 36-01) to lock the fly wheel and then remove the
nut by using a M12 socket wrench and a flywheel
removal tool (504 91 08-03). See figure 10.
3
Thread the mandrel (502 51 94-01) on the crank
pin. Screw until1-2 threads are left to the flywheel.
Knock on the mandrel with a suitable metal ham-
mer while at the same time pulling the flywheel
outward until the flywheel comes off the shaft.
Remove the mandrel and flywheel. See figure11.
4
Detach the ignition cable and loosen the screws.
See figure 12.
Cleaning and inspection
• Clean all parts, especially the tapers on the
flywheel and shafts.
• Check the flywheel for cracks or any other signs
of damage.
30
- English
Fig 9
Fig 10
Fig 11
Fig 12