Tensioning The Return Spring; Starter Assembly - Husqvarna 120 Workshop Manual

Repair Instructions

7.3 Tensioning the return spring

1
Lift the starter cord into the notch on the starter
pulley and turn the pulley about 3 turns clockwise.
Check that the pulley can be turned at least a fur-
ther 1/2 turn when the starter cord is pulled all the
way out. See figure 6.
2
Grab the handle and stretch out the starter cord.
Remove your thumb and let the cord spin back.
See figure 7.
Fig 6
Fig 7

7.4 Starter assembly

1
Position the starter against the crankcase and
tighten the screws with a tightening torque of
2 - 3 Nm, see figure 8.
Fig 8
29
English -