Advertisement
3. HOW TO USE THE APPLIANCE
HOW TO LOAD THE RACKS
UPPER RACK - depending on model:
Adjustable glass holder A Depending on the position, for small glasses or stemware.
Crockery holder
B Horizontal for: cups/long utensils, in raised position
for plates and stemware.
Long-handled utensils (kitchen knives) must be arranged with
the sharp end facing in towards the appliance.
Cutlery basket
C It can be placed on the upper rack when the "Half
load/Multizone" function is selected and there is no
divider inserted.
Rack height adjustment D The upper rack height can be changed even when
loaded:
Lower adjustment: pull out the two handles D and
Upper adjustment: pull the two handles D up until
The two handles D must be level.
Washing without the upper rack
If the appliance is equipped with the adjustable retainers shown in the figure, the
upper rack can be removed in order to accommodate large plates, trays etc.
Open the two retainers E and slide the upper rack out.
When the upper rack is in place the retainers must always be
closed.
LOWER RACK - depending on model:
Plate holders
F Fixed or flip-up (space-saving for
pots and pans).
Cutlery basket
G or
Cutlery basket
H It splits into two parts, the divider I
can be inserted to separate cutlery
to achieve a better wash.
Sharp utensils that might cause injury must be placed in the cutlery basket with the sharp end facing downwards. Arrange
crockery so that water does not collect in cavities, ensuring that the spray arms turn freely.
Only use dishwasher-proof crockery and dishes. Do not use the dishwasher for washing wooden items, aluminium, tin, silver
cutlery or decorated crockery (unglazed).
SELECT PROGRAMME
Press the programme selection button until the required programme appears (Table 1.1, Page 1). The appliance will switch on automatically. If required,
select options (if supplied). These are saved at the end of the cycle even if another programme is selected. The corresponding indicator lamp lights up.
WASH CYCLE
The dishwasher door must be closed and the water tap open.
To load crockery, open the door carefully (the Start indicator lamp will flash and a
beep will sound):
Beware of hot steam!
Press the Start button again. The programme resumes from where it was interrupted, with the door closed.
The wash cycle can be interrupted at any time by pressing Cancel/Off button. The appliance drains water for about 60 seconds
(with the door closed) then switches off automatically.
END OF PROGRAMME
Open the door carefully only after all the lights have switched off and a beep has sounded: hot steam may escape! Unload the appliance,
starting from the lower rack in order to avoid any residual drips of water falling onto crockery below.
For even better drying results, leave the dishwasher door open a little before unloading in order to allow the steam to dissipate, helping
the dishes to dry. The underside of the kitchen worktop must be protected (see instructions in "Maintenance and Installation").
gently lower the rack.
the rack clicks into place
(standard position).
A
Retainer closed
F
I
H
H
Changing the programme in progress/RESET
- Press the Cancel/Off button.
- Water drains automatically for up to 60 seconds with the door closed.
- Select the programme and press the Start button.
B
D
C
Retainer open
5
Advertisement
