Whirlpool ADG 7530 Installation And Maintenance Instructions Manual

Before using the dishwasher, read the installation and maintenance instructions carefully!
GB ADG 7530
Programme selection button
Press the button (repeatedly) until the indicator lamp of
the desired programme lights up (see table 1.1).
At the end of the wash cycle, the last programme
selected is memorized.
Detergent setting upon initial use and when using a
different type of detergent
Indicator lamp off = Powder/gel detergent (factory
setting).
If using combined detergents, press and hold the
button for 3 seconds; the indicator lamp lights up =
rinse aid and salt indicators are deactivated.
From water hardness level 5, the salt indicator remains
active. At the end of the programme, the most recently
selected setting remains memorised.
P
Programmes
1
Pre-Rinse
2
Quickwash
2)
3
Eco
4
Intensive
5
Half Load
1) Programme data obtained in conformity with European standard EN 50242. The data may vary, for example, according to
different loads, extra functions, different settings, water supply temperatures, water hardness and power supply voltage.
2) Programme for energy data label in conformity with EN 50242. - Information for Test Laboratories: for detailed information on the
EN/Standard loading comparison test and other tests, contact the following address: "nk_customer@whirlpool.com".
Whirlpool is a registered trademark of Whirlpool USA
1. OVERVIEW
Table 1.1.
Programme Table
Selectable
Description of programme
additional
options
cold
Crockery to be washed later.
Lightly soiled crockery, with no
45°C
dried-on food.
Normally soiled crockery. Energy-
50°C
saving programme.
Recommended programme for
70°C
heavily soiled crockery, especially
suitable for pots and pans.
Ideal for washing a half load of lightly
50°C
or normally soiled crockery.
Delayed Start button
Press the button repeatedly to delay the start of the
programme by 2, 4 or 8 hours. Then press the Start/Resume
button. The remaining time is indicated by the corresponding
indicator lamp. The wash programme will start after the set
time. The set delay will be memorised at the end of the cycle,
and can be selected by pressing the button again.
Start/Resume button
The indicator lamp lights up during operation, flashes
when the programme is interrupted before completion
and switches off at the end of the programme.
Cancel/Off button
Press the button to switch the dishwasher off or to
interrupt the selected programme.
If the Cancel/Off indicator lamp flashes repeatedly, this
indicates a fault: see chapter 5 "What to do if...".
Salt level indicator and rinse aid level indicator
These light up at the end of the programme if salt or
rinse aid needs topping up. Only add just before
starting a wash cycle.
Detergent
Consumption
compartment
large small Litres kWh
— — 4,0
X — 11,0
X X 12,0
X X 14,0
X X 10,0
5019 396 01199
1)
Minutes
1)
0,03 14 ±
1)
0,80 30 ±
1)
1,05 165 ±
1)
1,55 155 ±
1)
1,04 145 ±
1