Whirlpool ADG 7560 Quick Reference Manual
  1. Manuals
  2. Brands
  3. Whirlpool Manuals
  4. Dishwasher
  5. ADG 7560
  6. Quick reference manual

Whirlpool ADG 7560 Quick Reference Manual

Hide thumbs Also See for ADG 7560:
1
2
3
4
5
6
7
8
Table of Contents

Advertisement

Quick Links

Quick reference guide
ON
BUTTON
OFF
BUTTON
Table of programmes
P
Programmes
1
Pre-Rinse
cold
2
Quickwash
40°C
2)
3
50°C
Eco
4
Daily
60°C
5
Intensive
70°C
1)
Programme data obtained in conformity with European standard EN 50242, obtained under normal conditions (without
additional options) and may vary depending on conditions. Differences of up to 20 minutes are possible with sensor
programmes as a result of the appliance's automatic calibration system.
2)
Reference programme for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed
information on the EN/Standard loading comparison test and other tests, contact the following address:
"nk_customer@whirlpool.com".
PROGRAMME SELECTION BUTTON
Press button "P" (repeatedly) until the indicator of the required programme lights
up (see "Table of programmes" below).
START BUTTON
The indicator lights up during operation, flashes when a fault occurs and goes off at
the end of the programme.
START BUTTON RESET FUNCTION
Press this button for at least 2 seconds; the selected programme and options are
cancelled. Main failure displays (repeated flashing of the START indicator lamp) can be
cancelled by RESETTING. Detailed instructions are given in chapter "What to do if...".
Detergent
Loading instructions
Crockery to be washed later.
Lightly soiled crockery, with no
dried-on food. * Use of tablets
not recommended.
Normally soiled crockery.
Energy saving programme with
prolonged drying cycle.
Normally or heavily soiled
crockery.
Recommended programme for
heavily soiled crockery, especially
suitable for pots and pans.
BEFORE USING THE APPLIANCE FOR THE
FIRST TIME CAREFULLY READ THIS QUICK
REFERENCE GUIDE AND THE INSTALLATION
INSTRUCTIONS! THE GUARANTEE IS NOT
APPLICABLE IF FAULTS ARE CAUSED BY
INCORRECT USE OF THE APPLIANCE.
Consumption
1)
Litres
kWh
Minutes
—
5.0
0.02
10
X *
13.0 0.70
30
X
16.0 1.05
195
X
16.0 1.35
120
X
17.0 1.65
145
ADG 7560
5019 396 01767
Chart
GB -1-

Advertisement

Table of Contents
loading

Related Manuals for Whirlpool ADG 7560

Summary of Contents for Whirlpool ADG 7560

  • Page 1 Reference programme for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the EN/Standard loading comparison test and other tests, contact the following address: ADG 7560 5019 396 01767 “nk_customer@whirlpool.com”.

  • Page 2: First Time Use

    First time use How to set detergent type: powder/gel/tablet (if option is available) In order to always ensure the best cleaning 1. Select 3rd programme 2. Press START button 3a. Check your 3b..and set it on your dishwasher 4. Remember to use salt and rinse 5.

  • Page 3: Daily Check

    Daily check Filling the salt reservoir - Dissolve limescale (not necessary if water hardness level is set to “soft”!) Visual indicator (depending Add salt Visual indicator Fill the salt on model). Screw on the cap. (never add (depending reservoir with Salt residues around cap detergent!).

  • Page 4: How To Load The Racks

    How to load the racks How to load UPPER RACK (In some models only) B - Adjustable flaps: In horizontal position for cups/long utensils, (In some models only) in raised position for plates and stemware. A - Multipurpose support: Different positions for long C - Cutlery basket: It can be placed in the upper rack when the utensils, cups and glasses.

  • Page 5: Select Programme

    Select programme Quick, permanent or alternating Overview of programmes The max. possible number of programmes is illustrated in the chapter “Chart”. The corresponding programmes for your appliance can be found on the panel (page 1). Choose programme according to the attached table of programmes (page 1). Duration of the programme depends on the external conditions in the apartment, temperature and pressure etc.
  • Page 6 What to do if... If a fault occurs, before restoring normal appliance operation contacting the After-sales Service, make the following checks to try and remedy the problem. Most faults can be remedied by taking the following courses of action, quickly restoring normal appliance operation. The appliance...
  • Page 7 What to do if... Crockery and cutlery... Possible causes... Solutions..salt indicator lit - Use tablets for soft water. - Set “Detergent type” option; if this option is not available, it is normal for the salt indicator to light up..have deposits: regeneration salt residue - In areas with very hard water, more regeneration salt needs to be added (see page 2 “How to set water - Water too hard.

  • Page 8: Disconnect The Mains Plug

    What to do if... Disconnect the mains plug If, after carrying out the above checks, the fault persists, switch off the appliance, disconnect the mains plug and turn off the water tap. Contact the After-sales Service (see warranty). Before contacting our After-Sales Service, take note of the following: - the description of the fault, - the appliance type and model, - the service code (the number indicated on the adhesive rating plate) inside the door on the right-hand side:...

Table of Contents