Datavideo SE-800 Instruction Manual page 64

The new functions for unit' s serial number #0305000427 and after
In order to have these new functions, there are three firmware ICs need to be changed, which are
System ROM-A: V5.2 or higher
System ROM-B: V2.1
Video in boards (There are 4 channels Video input boards in SE-800): V5.0
Please Note: The items 1) to item 8) below are ROM-A (V5.2) and ROM B (V2.1) related function,
only the item 9) is Vin (V5.0) related function. You may change it accordingly.
The new firmware enables new features as below:
1). RS-232 interface control to SE-800 (For the Datavideo RMC-90 Remote control panel or for PC
RS-232 interface control)
2). On performing an effect transition, the selected A, B channel' s LED indicators on Main Source will
be both turned on.
3). Enable the main source output selection during the Input type mode selection.
4). Selectable DV audio ON/OFF
5). Selectable AGC ON/OFF control
6). Adjustable position (50 lines up/down) for external SDI overlay video.
7). Selectable internal Chroma-Key effect ON/OFF control
8). Consistency A/V LED for T-Bar.
9). Instant reset for individual video channel. (Vin firmware related)
Please see below for more detail description
.
1). Enable RS-232 interface for SE-800 Front Panel Control:
Connect the PC/MAC RS-232 interface to SE-800 for different application. (Note: Please see section
5 for the detail RS-232 control protocol)
Or connect to Datavideo RMC-90 remote control panel interface as below:
Datavideo RMC-90 Remote Control Panel
63