Datavideo SE-800 Upgrade Instructions
Se-800av to dv upgrade instructions
Hide thumbs
Also See for SE-800:
- Instruction manual (76 pages) ,
- Quick user manual (3 pages) ,
- Quick manual (2 pages)
Advertisement
Quick Links
Advertisement
Related Manuals for Datavideo SE-800
Summary of Contents for Datavideo SE-800
- Page 1 SE-800AV to DV Upgrade Instructions http://www.datavideo-tek.com...
- Page 2 Parts needed to upgrade the SE-800AV to SE-800: Item Description SDI OUT Module DV OUT Module DV IN Module IDE FLAT CABLE 26P(female)-26P(female) 50mm UL SDI board rear metal plate DV in board rear metal plate Screws 3 * 12mmblack...
- Page 3 Step1: Open the SE-800 top cover There is a screw inside this hole, that needs to be removed. There are another 7 screws on the bottom case to be removed and then you can lift off the top cover. Step2:...
- Page 4 Step3: Remove 10 rear panel screws Step4: Remove two metal braces, four AV IN Modules and one NO-SDI card NO SDI Card x 1 AV IN Module Card x 4...
- Page 5 Step5: Add four hex risers (17mm) onto the SDI Out Module Card with 4 (5.5mm) Nuts Description 17mm hex risers 3 * 5.5mm Nut SDI Out Module Card SDI Out Module Card Description Part number SDI OUT Module 305-SDI-OUT Part number 09160000171 09140301003 DV Out Module Card...
- Page 6 Step6: Put DV Out Module Card onto SDI Out Module Card with 4 ISO 3 * 8mm screws with the spring and washer. Add on the SDI rear panel with two f 3 * 12mm screws Description SDI board rear metal plate Screws f 3 * 12mm black Screws ISO 3 * 8mm with spring and washer Step7: Add four hex risers (20mm) on the AV IN Module Card and fasten with Nuts...
- Page 7 Step8: Connect the IDE FLAT CABLE on to J2 of the DV IN Module Card (Please note: the red line on cable should match Pin 1 of J2) DV IN Module Card Description DV IN Module IDE FLAT CABLE 26P 50mm UL Step 9: Adjust the NTSC/PAL J4 Jumper setting on DV IN Module Card Short on 1&2 for NTSC System Short on 2&3 for PAL System...
- Page 8 Step 10: Replace the original AV IN Module Card plate with the DV module plate. DV module rear Plate Description Part number DV module rear plate (6-Pin DV) 09310003053 Step 11: Add four ISO 3 * 8mm screws onto the DV IN Module Card Connect the 26-Pin FLAT CABLE from the DV to AV card AV IN and DV IN Module Card Description...
- Page 9 Step12: Follow Step 7 to Step 11 to assemble the three remaining DV and AV modules. Install all the modules with SDI/DV Out Module back onto the SE-800 PCI slot. (Shown below) Step13: Attach the metal braces to secure the modules.
- Page 10 Note: The direction of the metal brace assembly. Note: The direction of metal brace assembly. Fasten all four screws (two per side)
- Page 11 Step14: Step15: Put the top cover on and fasten the screws. There is a screw inside this hole and another 7 screws on the bottom. Fasten 10 screws...