Troubleshooting; Introduction - Troubleshooting; Error Icons In The Automower; Access Display - Husqvarna AUTOMOWER 435X AWD Operator's Manual

6.1 Introduction - troubleshooting

In this chapter, a number of messages are listed which may be shown in Automower
®
Automower Access if there is a malfunction. There is a proposal action to the cause and steps to take
for each message. This chapter also presents some symptoms that can guide you if the product does
not work as expected. More suggestions for steps to take in the event of malfunction or symptoms can
be found on www.husqvarna.com.

6.2 Error icons in the Automower

If an error icon is shown in the Automower
and return to the main menu. More information about the error can be found in Automower
Error icon Description
The product has stopped because of
an unexpected situation.
The product has stopped because of
an unexpected behavior from the wheel
motors.
The product has stopped because the
loop signal is missing.

46 - Troubleshooting

6 Troubleshooting
®

Access display

®
Access display, push the STOP button to confirm the error
Action
Examine if the cause of the problem is
obvious. For example, if the product is
not in the work area or if the product is
in top of an object (stone, branch, etc).
Restart the operation of the product.
Examine the drive wheels and remove
grass or other objects. Restart the op-
eration of the product. Contact your lo-
cal Husqvarna representative if the
problem is frequent.
Refer to the error message "No loop
signal" in
®
Connect and
®
Connect.
Fault messages on page 47 .
1404 - 002 -