BT DF60 User Manual page 21

Incoming messages and memos
An incoming message (ICM) is the message a
caller leaves on your answering machine if you
are not able to take the call yourself. Memos
are treated in the same way as incoming
messages but are recorded using the handset
(see page 21).
Message indicator
YES NO
When a message has been left on your DF60's
answering machine a black square will flash on
the right hand side of the liquid crystal display.
Your DF60 also incorporates an audible
message indicator which is pre-set to
facility gives a short beep every 6 seconds to
indicate that new messages have been
received.
To switch the audible indicator off
Press the TAD button.
•
Press the button.
•
Press the YES button until the display
•
shows :
MESSAGE BEEP: ON
Press the NO button to switch between
•
and .
OFF
Press the YES button.
•
Press the STOP button.
•
To check the number and time of messages
You can check how many messages you have
and the time that they were received.
•
•
•
To play back messages
To listen to a message (ICM) or memo left on
your answering machine:
•
•
. This
ON
Once playback has started, if you prefer messages
can be listened to through the handset.
If you have more than one message they are
played back in the order they were recorded.
If you have no messages display shows:
.
MESSAGE EMPTY!
ON
To pause while listening to your messages,
press the
again to resume playback.
Press the FUNCTION button followed by
the button.
The display shows:
TOTAL MESSAGE: XX
followed by:
MESSAGE (01)
time the first message was received.
The display then shows:
so on until all messages have been displayed.
Press the TAD button and the display will
show:
TAD FUNCTION
Press the II button and the display will
/
show the time and date of your first message
and then:
MESSAGE (01)
then automatically play back the message
through the speaker.
II button. Press the
/
Using the answering
machine
and the date and
and
MESSAGE (02)
, your DF60 will
II button
/
18