Table of Contents
Advertisement
Before You Start
IMPORTANT
SAFEGUARDS
1
Be sure to connect the color-coded leads
according to the diagram. Incorrect
connections may cause the unit to
,
malfunction or damage the vehicle s
electrical system.
2
Be sure to connect the speaker (-) leads
to the speaker (-) terminal. Never connect
the left and right channel speaker cables
to each other or to the vehicle body.
3
Make sure all the connections are completely
correct before turning on your unit.
4
When replacing the fuse(s), the replacement
must be of the same amperage as shown
on the fuse holder.
5
Do not block vents or radiator panels as
that would cause heat to build up inside
the unit could result in fire.
About this manual
The interface has been designed for the
easiest possible use, but many functions
are not self-explanatory, so please take
the time to review this manual.
Additional Information
Troubleshooting Common Problems
The following suggestions may solve some common problems. Please make sure that the
connections and the operating procedures have been followed properly before using the
following checklist.
Problem
.
Cause/Solution
No power
.
The display malfunctions,or
the buttons have no effect
.
Unable to receive stations
. .
Poor radio reception
.
. .
CDs cannot be loaded
Sound skips
.
No images
.
Images skip
Note:
If problems persist after trying these suggestions, consult a service dealer. Never attempt to disassemble
your unit by yourself.
Due to continuous product improvement, the instructions
in this manual are subject to change.
If you are in need of technical support, please email us at
TechnicalSupport@DPAudioVideo.com
or visit our website www.DPAudiovideo.com
Make sure the fuse is not blown, replace with
the proper value if necessary.
Press the RESET button.
Make sure the antenna is inserted and properly
connected.
Make sure that the antenna is
1)fully extended
2)unbroken
3)properly grounded at its mounting location.
Make sure a disc is not already loaded.
Make sure the disc is not dirty or damaged.
Make sure the video line from the unit to the TV
is connected properly.
Make sure the color system is set to PAL or NTSC,
depending on your location or television.
41
08
Advertisement
Table of Contents
