Quick Reference Guide - Viper 5000 Owner's Manual

QUICK REFERENCE GUIDE

To arm using your LCD remote
You can activate, or arm, the system by pressing
➤
second. When the system arms, you will hear a short siren sound, or chirp, and
the parking lights will flash once. If the vehicle's power door locks have been
connected to the system, the doors will lock.
To disarm using your LCD remote
To disarm the system, press
➤
lights will flash twice. If power locks are connected to the system, the doors will
unlock. If the siren chirps either four or five times when disarming, see
Diagnostics section. This is called Tamper Alert.
Arming while driving
Press on your remote for two second while the vehicle is running. The
➤
system will chirp once and then once more to indicate that the ignition is on.
Disarming without a LCD remote
Turn on the ignition. Press and release the Valet
➤
number of times within 15 seconds. After five seconds, the system will disarm.
If it does not, you may have waited too long. Turn the ignition off and on and
try again.
To enter or exit Valet
Turn ignition to RUN position, then turn to OFF position. Press and release
➤
the Valet button within 10 seconds. The in-vehicle status LED will light solid
®
if you are entering Valet
Mode.
To activate Panic Mode
Press and hold
➤
To exit Panic Mode
Press on the remote.
➤
To activate Silent Mode™
Press briefly before arming or disarming, and the confirmation chirp(s)
➤
will be eliminated for that one operation only.
Location of Valet ® Button_______________________________
Number of Valet ® Button pulses for disarming_____________
© 2005 directed electronics, inc.
. You will hear two chirps, and the parking
® Mode
® Mode, and it will go out if you are exiting Valet
down for approximately two seconds.
on your remote for one
button the programmed
®
®
61