Power Saver Mode; Programming Options - Directed Electronics Concept 550 Owner's Manual

power saver mode

Your system will automatically enter Power Saver Mode while armed or
in Valet Mode, after a period of time in which no operation has been
performed. This lowers the current draw on the vehicle's battery and
prevents the system from draining the battery. Power Saver Mode takes
over under the following conditions:
Power Saver when the system is armed: After the system has
been armed for 48 hours, the LED will flash at half its nor-
mal rate, decreasing the system's current draw.
Power Saver in Valet Mode: When the system enters Valet
Mode the LED illuminates steadily. If the vehicle is not used
(ignition is not turned on) for a period of one hour while the
system is in Valet Mode, the LED will shut off. If the system
remains in Valet Mode, the LED will come back on the next
time the ignition is turned on and then back off.

programming options

Programming options control what your system does during normal
operation, and require few or no additional parts. However, some may
require additional installation labor.
Following is a list of the program settings, with the factory settings in bold:
Active arming (only with the transmitter) or passive arming
(automatic arming 30-seconds after the last door is closed).
18