auxiliary channel bypass
Alarm sensor input zones one, three, and eight will be bypassed while
a pulsed or timed auxiliary Output is active.
panic mode with smart door locking
If you are threatened in or near your vehicle, you can attract attention
by triggering the system with your transmitter! Just press
two seconds to enter Panic Mode. The siren will sound and the park-
ing lights will flash for the programmed duration. If the ignition is on,
the doors will lock; if the ignition is off, the doors will unlock. To stop
Panic Mode at any time press
disarm/valet mode
Entering your pin code using the PlainView 2 Valet switch allows you
to disarm the system or enter valet mode without using the transmit-
ter. In valet mode, the security system will not arm, even with the trans-
mitter, but all convenience functions (door locks, trunk release, etc.)
will continue to work normally.
To disarm or enter Valet Mode:
1. Turn the ignition on.
2. Enter PIN code (factory setting is 2).
© 2 0 0 4 d i re c t e d e l e c t ro n i c s , i n c .
on the transmitter again.
for