Zanussi ZWF50820WW User Manual page 12

You can cancel or change the set of
the Delay Start
press the button Start/Pause
After pressing the button Start/Pause
you can only cancel the Start/
Pause option.
To cancel the Delay Start
a. Press the button Start/Pause
the appliance to pause. The indicator of
button flashes.
b. Press the Start/Pause button
start the programme immediately.
INTERRUPTING A PROGRAMME AND
CHANGING THE OPTIONS
You can change only some options before the
programme carries them out.
1. Press the Start/Pause
the running programme.
The related indicator flashes.
2. Change the options.
3. Press the Start/Pause
The programme continues.
CANCELLING A RUNNING PROGRAMME
1. Turn the programme knob to position
cancel the programme and to deactivate the
appliance.
2. Turn the programme knob again to activate the
appliance. Now, you can set a new washing
programme.
Before starting the new programme
the appliance could drain the water. in
this case, make sure that the detergent
is still in the detergent compartment, if
not fill the detergent again.
OPENING THE DOOR WHEN THE DELAY
START OPERATES
While the delay start operates, the appliance door
is locked and the panel shows the indicator
1. Press Start/Pause
2. Wait until the door lock indicator
3. Open the door.
4. Close the door.
5. Press Start/Pause
The delay start continues to operate.
12
option before you
.
option:
to set
again to
button to interrupt
button again.
to
.
to pause the appliance.
goes off.
again.
OPENING THE DOOR WHEN THE
PROGRAMME OPERATES
While the programme operates, the appliance door
is locked and the indicator
CAUTION! If the temperature and
level of the water in the drum are too
high, you cannot open the door.
1. Turn the programme knob to position
deactivate the appliance.
2. Wait some minutes until the indicator
off and then open carefully the appliance door.
3. Close the appliance door.
4. Set the programme again.
AT THE END OF THE PROGRAMME
• The appliance stops automatically.
• The acoustic signal operates (if it is activated).
• In the display three flashing zeros come on.
• The indicator of the Start/Pause
• The door lock indicator
• You can open the door.
• Remove the laundry from the appliance. Make
sure that the drum is empty.
• Close the water tap.
• Turn the programme knob to the position
deactivate the appliance.
• Keep the door ajar, to prevent the mildew and
odours.
The washing programme is completed, but
there is water in the drum:
• The drum turns regularly to prevent the creases
in the laundry.
• The door lock indicator
stays locked.
• You must drain the water to open the door.
To drain the water:
1. Turn the programme knob to spinning or
draining programme.
2. Press the button Start/Pause
decrease the spin speed.
The appliance spins and drains or only drains.
3. When the programme is completed and the
door lock indicator
the door.
4. Turn the programme knob to the position
deactivate the appliance.
The appliance drains and spins
automatically after approximately 18
hours (except for Wool programme).
appears.
to
goes
goes off.
goes off.
to
is on. The door
. If necessary,
goes off, you can open
to