Port Mapping / Virtual Servers - D-Link DFL-1100 Installation Manual

Port Mapping

Port Mapping / Virtual Servers

The Port Mapping / Virtual Servers configuration section allows you to configure virtual servers such as Web servers.
Mappings are read from top to bottom. The first matching mapping is carried out. The Port Mapping / Virtual Servers
configuration screen can be found by going to the Firewall tab and clicking on the Port Mapping button.
Adding a New Mapping
e
1. Click the Add new
2. Fill in the following values:
Name
Action
Source Nets
Source
Users/Groups
Destination
Nets
Destination
Users/Groups
Service
Schedule
4. If using Traffic Shaping, fill in the appropriate information. If not, skip this step.
5. Click Apply to apply the settings or click Cancel to disregard the changes.
link.
Create a name for the policy. This name is used mainly as a rule reference in log data and for easy
reference in the policy list.
Select the action to be performed with the specified data.
Specifies the sender span of IP addresses to be compared to the received packet. Leave this blank to
match everything.
Here you can specify that a username, group, or any authenticated user must be the source for the action to
occur. A list of usernames can be entered, separated by a comma, or write Any to represent any
authenticated user. If it's left blank there is no need for authentication for this policy.
Specifies the span of IP addresses to be compared to the destination IP of the received packet. Leave this
blank to match everything.
A specific username can be specified for this policy to match. A list of usernames can be entered,
separated by a comma, or write Any for any authenticated user. If it's left blank there is no need for
authentication for this policy.
A predefined service can be selected from the dropdown menu or a custom service can be created.
Select what schedule should be used for this policy to match. Choose Always for no scheduling.
19
DFL-1100 Installation Guide